Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Touch sensing design and water

Status
Not open for further replies.
D

danvica

Newbie
Newbie level 4
Joined
Aug 23, 2012
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Italy
Activity points
1,320
Some times ago I developed a touch sensing wheel that works pretty well in dry enviroments.

You can see a picture and a small video:

touchwheel.jpg



Unluckly it was suppose to work in very wet conditions... and it didn't work, so I stopped the development.

Now I'd like to restart the project.

My question is: Have you experience of touch sensing pad/wheel in underwater system ?

Thanks.
 

I came across this one. May not be upto your requirement but i think helpful

ww1.microchip.com/downloads/en/AppNotes/01286A.pdf
 
Thanks, I already red some ANs (not this one,thanks again) from microchip but I would like so much to avoid the test-and-modify phase.

In the current project, the one shown in the movie, I used a QT1106 device from Quantum, now Atmel. Pretty simple to implement in dry conditions.

I hoped to get a water-resistant project just modifying this chipset but you are confirming me that, most probabily, the best choice is using a microcontroller and the right algorithm: I have to agree.

Still: anyone has any experience ?

Thanks.
 

Hi,
I have experience with Atmel Touch design, and did evaluation for outside/raining conditions with the AT1070 eval. kit (AT42QT1070 device). In the 1070 you can actually play with thresholds to set it for rainy conditions so it will recognize touch of the finger even if there is water on the sensor. It was a button design, not a wheel like you have on yours, but would still work on wheel I assume.
With the wet conditions I think you should use the device that has this internal register settings for sensitivity, as opposed to the non-register settings ones where you can only change the resistor to adjust the sensitivity.
The 1070 kit is great for this purpose as proof of concept, and easy to use.
 
Thanks for the suggestions, I'll study the Atmel docs more carefully.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top