Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How can I define two port as input at tne same time?

Status
Not open for further replies.
T

tw20053010

Member level 1
Member level 1
Joined
Oct 24, 2004
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
293
Dear Sir:
I am trying to simulate an anntena, but I need two wave port to input.
I am not sure how to define two input port at the same time. I just chose both two retangular ports and define them as wave port1. But when running the simulation,the the system said as follow:
[error] Port refinement, process abc3d died unexpectedly. (12:00 PM Oct 25, 2004)
[warning] Warning - Boundary 'PerfE1', Boundary 'WavePort1' : Boundaries overlap. (11:56 AM Oct 25, 2004)

And also I donot know which size I need to define a outer radiation box?I think it should relate to the annten radius.(my antenna is circule)
Could you help me?
Thank you very much!!
 

tw20053010 said:
Dear Sir:
I am trying to simulate an anntena, but I need two wave port to input.
I am not sure how to define two input port at the same time. I just chose both two retangular ports and define them as wave port1. But when running the simulation,the the system said as follow:
[error] Port refinement, process abc3d died unexpectedly. (12:00 PM Oct 25, 2004)
[warning] Warning - Boundary 'PerfE1', Boundary 'WavePort1' : Boundaries overlap. (11:56 AM Oct 25, 2004)

And also I donot know which size I need to define a outer radiation box?I think it should relate to the annten radius.(my antenna is circule)
Could you help me?
Thank you very much!!
Click to expand...

hi
error is not because of defining two ports at the same time. for my coupler, I defined 4 ports. however, type of the port may change the way you should define the ports. as an example, for a coax, you should define bottom faces of the outer and inner parts as a wave port.
when you define radiation boundary, choose 5 faces of the air box and assign it as a radiation boundary, sixth face is the one just below the antenna.
If you send your design, it may easier to comment.
 

    T

    tw20053010

    Points: 2
    Helpful Answer Positive Rating
I suspect you didnt correctly set the port, which kind of ports are you using? Waveport, I assumed. To define a waveport, you must have a rectangular or circular (even more complex) planar shape object. You can assign this object to exciation- waveports. But, keep in mind, this port must physically support the connect, the excitation(including the ground and the trace). For example, microstrip line, the rectangular box must touch ground plane.
Best Regards,
 

    T

    tw20053010

    Points: 2
    Helpful Answer Positive Rating
HFSS provides a simple mode, terminal mode, you can choose HFSS->solution type->Driven terminal.
Then, you will find it is easy to define port, and it will be faster than before when simulating.
 

    T

    tw20053010

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top