Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Simulation of CB-CPW on ADS momentum in the W band

Status
Not open for further replies.
S

Shehata

Member level 3
Member level 3
Joined
Jan 22, 2010
Messages
62
Helped
12
Reputation
24
Reaction score
11
Trophy points
1,298
Location
Waterloo, Ontario, Canada
Activity points
1,620
Hi

I am trying to simulate CB-CPW on ADS momentum. I am a bit worried about the ground port definition in momentum. Any clue?

Thanks
 

Slot line are created using slot definition to the layer mapping in substrate editor. Its a negative artwork. your can follow following steps to create your design
1) Create a design negative to your desired design(remember you need to create design of the vacant slots in layout using draw polygon/rectangle option)
2) Now map the layer in substrate as slot.
3) Now View the structure in 3D Viewer, the viewer should show the desired design.

------
Amit
ADVERTISING LINK REMOVED
 
Thanks a lot!

I want also to add that this type of simulation agrees with HFSS if you make sure that the modes are slot e.g. no parallel plate modes

Attached is a snapshot for a simple CPW line. The figure shows the agreement between HFSS and momentum

Picture1.png
 

You can also cross check with ADS FEM, the results would be same.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top