Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

DC motor to servo motor...

Status
Not open for further replies.
U

uday mehta

Advanced Member level 4
Full Member level 1
Joined
Dec 30, 2011
Messages
104
Helped
6
Reputation
12
Reaction score
6
Trophy points
1,298
Visit site
Activity points
1,979
the basic difference b/w servo motor and dc geared motor is feedback.
then is it possible to convert a geared dc motor into servo motor?
If yes then how?
 

The answer is in your question.....................

- - - Updated - - -

Add a feedback on the shaft and all the required electronics and firware.
Read this - it may help :
http://www.societyofrobots.com/actuators_servos.shtml#control
 
It's little bit complicated than simply adding control hardware to a common DC motor to make it as a servo. That is why servo motors are specially built to facilitate servo control circuit.
Following is a on how to do that conversion;
**broken link removed**
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top