Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Allowing routing errors in Altium 10....how?

Status
Not open for further replies.
G

grizedale

Advanced Member level 3
Advanced Member level 3
Joined
Jun 13, 2011
Messages
838
Helped
17
Reputation
34
Reaction score
17
Trophy points
1,298
Activity points
8,804
Hello,

I am routing a PCB with Altium 10.
Every now and then I want to allow errors so that I can get a “scout” track in.

So how do I “Allow errors”?
 

In Interactive Routing select the none option in Routing Conflict Resolution as shown in Image below.



You can also search for your queries at https://wiki.altium.com.
This websites has the solution to most of the queries.
 
unfortunatley , like all the other high end pcb layout packages, the online help and information is pretty poor.
All thats needed is a simple "cal a spade a spade" lesson say to put three resistors in the library then scm than pcb then gerber, but NO pcb layout software does this simple and ohsoneeded thing.

The only one that does do it is eagle, but eagle does not have net ties
 
Last edited:

Yes you are right but I have not used Eagle so cant comment on it.
From most of the tools I have used I found Altium online help best.

- - - Updated - - -

Yes you are right but I have not used Eagle so cant comment on it.
From most of the tools I have used I found Altium online help best.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top