Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Drawing and moving rectangles in Altium 10 PCB Library editor?

Status
Not open for further replies.
G

grizedale

Advanced Member level 3
Advanced Member level 3
Joined
Jun 13, 2011
Messages
838
Helped
17
Reputation
34
Reaction score
17
Trophy points
1,298
Activity points
8,804
How do you draw squares in Altium 10 PCB library editor?

-then , when the squares have been drawn, how do you move them by their centre and snap the centre to the centre of the component footprint.

As you know, the component courtyard, is generally square , and this is needed for collision avoidance and to extrude up from to get the 3D collision avoidance/appearance.
 

Hi,
Select layer top overlay and place line and make square as per drawing details given in datasheet.
 
yes thanks.....but how do i move the square by its centre and snap the squares centre to the reference point?

Basically what i am asking, is how do i get the "snaps" feature as seen in Cadstar?
 
Last edited:

Hi,
I have not used cadstar, may be following detail may help you
After finishing placing line set origin to center of component (Edit/set reference to center).
 
thanks but i find that just sets the reference in between the pads
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top