Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] glcd interfacing with 8051

Status
Not open for further replies.
P

pratzz

Member level 5
Member level 5
Joined
Jun 15, 2012
Messages
83
Helped
6
Reputation
12
Reaction score
6
Trophy points
1,288
Activity points
1,781
i copied the code from engineersgarage.com and checked its functioning on proteus but on hardware implementation nothing is displayed just backlight seems to be glowing. i have used JHD12864e .Also 18th pin(Vee) is showing only +0.3 v. can anyone help me?
 

Don't Worry..
I will give you the code when i reach home...

I had used the JHD12864E and interfaced with PIC16F877a..

Till then u upload your code and Schematic Diagram
 

i actually used 8051,code seems to be rnning correctly on proteus.

**broken link removed**


I'm not sure whether my glcd is wrkin because i accidently gave pin no. 18 +5v for a short while.
 

I think your code is Okay....

But if it is possible for u to give the Circuit Diagram (Schematic) so that i can know how you connect your hardware...

As I am also using JHD12864E and its working for me....

Have you used a potentiometer between Vout Pin and VEE

Measure the Voltage on Vee pin.. i think it must be negative..
Check that and report back...

Tutorial on Graphical LCD can be found here

https://sites.google.com/site/coolembeddedlaboratory/home/pic18f4550/tutorial-list/graphical-lcd
 
  • Like
Reactions: pratzz

    P

    pratzz

    Points: 2
    Helpful Answer Positive Rating
schematic is exactly like that given in the link below.

**broken link removed**

yes i have connected the potientiometer but value at 18th pin is comin out to be +.3v.
 

my glcd was damaged.thnak u for helping me
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top