vishaletm
Banned
as what i search is using 3 - 4 voltage, and the resistor connected b4 Led is 180Ohms.
my Circuit do not run the function other than led program
If your code works fine in proteus, then try connecting normal LED with a 220 ohm or 330 ohm resistance in series with the outputs, so that you can rectify the circuit. If problem is with the circuit this will works fine, try it on a breadboard if possible. First of all burn the program to PIC once again, then use a breadboard if u have one, then your circuit works fine.
Please check the MCLR pin where did you connected it? its not clear in circuit. Connect it separately to VCC by a 10K res, dont use this resistor to pull up an input pin , if you do it so when low input is applied it will reset.