Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

pspice simulation of Jfet

Status
Not open for further replies.
E

electronic_satya

Member level 2
Member level 2
Joined
May 17, 2011
Messages
49
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,662
Hi all,

I am trying to simulate a JFET in orcad Pspice and i am facing the following problem

The pspice calculation of the drain current is different from my hand calculation. Could somebody please explain me where am i making mistake?

The JFET iam using is J2N3819 and the model parameters are

.model J2N3819 NJF(Beta=2.0m Betatce=-.5 Rd=1 Rs=1 Lambda=2.25m Vto=-3
+ Vtotc=-2.5m Is=33.57f Isr=322.4f N=1 Nr=2 Xti=3 Alpha=311.7u
+ Vk=243.6 Cgd=1.6p M=.3622 Pb=1 Fc=.5 Cgs=2.414p Kf=9.882E-18
+ Af=1)
* National pid=50 case=TO92
* 88-08-01 rmn BVmin=25

My calculation

@Vgs = 0V

ID = IDSS = Beta * Vto ^2
= 2 * 9 = 18mA

Pspice calculated value
2.446mA

Thanks in advance,
Regards,
Satya
 

Attachments

  • jfet.JPG
    jfet.JPG
    8.1 KB · Views: 141

The resistor is limiting the current. With 4K, you can't get more than 10V / 4K = 2.5mA.
 

Hi,
Thank you very much for the reply. I have one more small clarification here the JFET in the circuit is actually capable of giving IDSS (=18mA here) but not able to give so much current because of external circuit. Does it mean that the JFET performance characteristics are actually dependent on the external circuit?

Thanks in advance,
regards,
satya
 

electronic_satya said:
Does it mean that the JFET performance characteristics are actually dependent on the external circuit?
Click to expand...
Sort of. If you look in the datasheet, you see that IDSS is the drain current when Vgs = 0 and Vds = 15V. So it will be different with different drain voltages.

From the curves below, you can see the current does not change much when VDs is more than about 4V, so IDSS is almost constant, except at low voltages.

There's something else very important to know about JFETs; If you look in the datasheet, it says IDSS is "2mA minimum, 10mA typical, 20mA maximum". That means that if you buy 10 of them, they will probably all be different.

 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top