Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Input filtering for thermocouple

Status
Not open for further replies.
D

denujith

Member level 5
Member level 5
Joined
Oct 5, 2010
Messages
85
Helped
6
Reputation
12
Reaction score
6
Trophy points
1,288
Activity points
1,886
I am trying to interface Type-S thermocouple to a PIC. I am using INA126 amp for amplification. For input filtering found below circuit diagram. But I can't understand its operation.

Can anyone give me any help understand the filter operation it would be a great help. I have attached the filter circuit for your reference...
filter.JPG
 

The filter on the schematic is rather an interference suppressor as the leads from the thermocouple to opamp input may be long and not screened. As a thermocouple usually has a slow response (1...5 Hz), you can also use a feedback capacitor in the opamp circuit to make it operate as a low-pass filter.
For thermocouples, instrumentation-type amplifiers are often used which suppress CMR and interference while offering a reasonable gain. Thermocouples have a low resistance, so they are less problematic than other temperature sensors.
 
@jiripolivka Thank you a lot for your input (Y). By the way can you please explain a little bit about "CMR"? Google didn't help.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top