Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Why use bandgap reference voltage 1.024V???

Status
Not open for further replies.
D

diarmuid

Full Member level 2
Full Member level 2
Joined
Aug 4, 2011
Messages
143
Helped
10
Reputation
20
Reaction score
9
Trophy points
1,308
Location
Dublin, Ireland
Activity points
2,429
Hello!

I have seen bandgap voltages of 1.024V being used by ADC's, where the other analog blocks make do with 1.2V.

Why does an ADC need such a reference voltage? Its something to do with 2^10 I presume, but not being an
ADC guru, I cant say what!

Thanks in advance,

Diarmuid
 

Hi diarmuid!

So, why 1.024V, it's for 1LSB => good for standardization of ADC. ;-)
And normally, this is reference voltage, i think it should not be called bandgap ref voltage, because the typical bandgap voltage is between 1.2 - 1.3 V, it is based on the theoretical value for silicon is 1.22eV at 0K.
 
Last edited:
  • Like
Reactions: butchi

    B

    butchi

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top