Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

output voltage of LM35 in proteus

Status
Not open for further replies.
M

maria khan

Newbie level 3
Newbie level 3
Joined
Apr 14, 2012
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,308
i want to see the output voltage of LM35 with temperature increas in proteus ISIS....
would anyone plzzzzzzzzzzz help me....???
 

Re: output voltagr of LM35 in proteus

maria khan said:
i want to see the output voltage of LM35 with temperature increas in proteus ISIS....
would anyone plzzzzzzzzzzz help me....???
Click to expand...
Try this. If you just want to see the output voltage, connect a voltmeter between Vout(2nd Pin) and the GND(3rd Pin). Then 1st pin to 5V DC. As you increase temperature from 0to150 Deg, you can see the voltage increasing from 0-1.5V on The voltmeter. To increase the temperature use the arrow signs on the LM35 in Proteus.
If you want to check for negative temp I don't think the LM35 sensor given in Proteus will be of much use.
 
maria khan said:
i want to see the output voltage of LM35 with temperature increas in proteus ISIS....
would anyone plzzzzzzzzzzz help me....???
Click to expand...


Simply attach a voly meter between its out put & ground pin and observe
 
u can take a virtual voltmeter and connect to the gnd and out pin , and when u run the simulation u can get the value on the voltmeter!
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top