Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Good Clock frequency for General Purpose FPGA design

Status
Not open for further replies.
digi001

digi001

Full Member level 5
Full Member level 5
Joined
Apr 5, 2011
Messages
244
Helped
22
Reputation
44
Reaction score
21
Trophy points
1,298
Activity points
2,904
I'm looking for what would be a good clock frequency for a general purpose FPGA design. The FPGA currently preforms some basic counting and sequencing for industrial control functions but could expand to future field applications where necessary. Currently it uses a 37.5Mhz clock from a DSP that resides on the same PCB, but I'd like to add one more for standalone operations.

Would 10Mhz or 20Mhz be a good choice?
 

That depends.
What is the fastest frequency you intend to run future designs at?
If it's a large FPGA, with many registers I'd pick a much faster clock - In the range of 150 Mhz.
 
  • Like
Reactions: digi001

    digi001

    digi001

    Points: 2
    Helpful Answer Positive Rating
Cant I always multiply up a 20Mhz to 150Mhz? The FPGA I am using has 3 built in PLLs.
 

You can, but why should you?
Lowering the speed is easier than accelerating it.
 
  • Like
Reactions: digi001

    digi001

    digi001

    Points: 2
    Helpful Answer Positive Rating
True but lots of high speed clocks on a PCB can sometimes cause EMI issues?
 
Not really.
You do need to take special care of high speed signals however.
It's the rise/fall times you should look at when analyzing signal integrity issuse - not the direct frequency.

If you worry about radiation, you can route the signal as a microstrip (not a stripline).
Use proper terminations and keep the trace as short as possible.
 
  • Like
Reactions: digi001

    digi001

    digi001

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top