Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

simulating the "Stripline parallel-coupled lines filter" on Advanced Design System

Status
Not open for further replies.
R

ramin.ala

Junior Member level 1
Junior Member level 1
Joined
Dec 13, 2010
Messages
19
Helped
7
Reputation
14
Reaction score
7
Trophy points
1,283
Location
!
Activity points
1,429
simulating the "Stripline parallel-coupled lines filter" on Advanced Design System

How can I draw the microstrip parallel-coupled lines in ADS (the file be attached in this post, shows the structure). In fact, these lines with unequal length, offset beginning position and desired angle are used frequently for designing the band-pass filters. suggested structure must be considered the coupling effect between lines.
 

Re: simulating the "Stripline parallel-coupled lines filter" on Advanced Design Syste

There should be an option for importing the layout from AutoCAD into ADS.
Draw the layout in AutoCAD and import into ADS.

-sv
 

Re: simulating the "Stripline parallel-coupled lines filter" on Advanced Design Syste

Have a look at the ADS example mw_filter_prj

 

Re: simulating the "Stripline parallel-coupled lines filter" on Advanced Design Syste

Use "Passive Circuit DG - Microstrip Circuits" if you have license..
It's much easier than drawing..
 

Re: simulating the "Stripline parallel-coupled lines filter" on Advanced Design Syste

sv1437 said:
There should be an option for importing the layout from AutoCAD into ADS.
Draw the layout in AutoCAD and import into ADS.

-sv
Click to expand...

thank you. but imported file cannot consider the coupling effect. in addition, how can I use the imported file in schematic design (maybe those file are useful in momentum but how about optimization and ...)

---------- Post added at 12:23 ---------- Previous post was at 12:18 ----------
volker_muehlhaus said:
Have a look at the ADS example mw_filter_prj

Click to expand...

thank you. but I think this structure is different with my request. Look at the angle of the strips.

---------- Post added at 12:26 ---------- Previous post was at 12:23 ----------
BigBoss said:
Use "Passive Circuit DG - Microstrip Circuits" if you have license..
It's much easier than drawing..
Click to expand...

thank you. but I cannot find any structure in "Passive Circuit DG - Microstrip Circuits" regarding my request.
 
Re: simulating the "Stripline parallel-coupled lines filter" on Advanced Design Syste

ramin.ala said:
but I think this structure is different with my request. Look at the angle of the strips.
Click to expand...

The only difference is the bend at the filter input/output. You can use element MBEND.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top