Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Please Take a look at 900Mhz Patch antenna!

Status
Not open for further replies.
S

SaadRiazQazi

Junior Member level 3
Junior Member level 3
Joined
Feb 1, 2011
Messages
27
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
Pakistan
Activity points
1,437
This is the 900Mhz antenna we have designed by consulting Balanis's antenna theory book but the dip is way off the 900Mhz freq that we want. Can some one please check this and tell us the error we are making?
 

Attachments

  • 900_error.rar
    8 KB · Views: 83

Hello,

Maybe you can post an image with size reference, relative permittivity, etc. This enables more people to answer your question.
 

starting to run your design.first thing that was noticed was the simulation didn't converge. antennas is not well matched to 50 ohm. waveport instead of lump port. will pst your file here after the simulation are finalized

Best regards
Sajid Mohammed.
 
Sir Sajid I will be very thankful for your favour.

Sir this antenna has matching issues, I have optimized it a lot but cannot seem to get it right. I have been optimizing its inset distance Yo but no success so far.
 

Dear Saad

I have worked on your patch and set the values,i can copy the values here if you would like. the size of the patch and length were changed to get resonance along with the inset point and there was good resonance at that frequency .Unfortunately the gain is not upto par.because of the FR4 substrate.

Best Regards
Sajid Mohammed.
 
Sir Sajid kindly post the modified design or values here so that all can benefit from it as I was in much difficulty to get this right. Sir I need a range of hardly 6-10 meters so I think that even less gain will do the job for me.

Regards
 

everything stayed the same except i just changed the size of the patch i.e $L,$W and $farz $w0 are here respectively 68, 162,123.57,3.05

Hope that helps

Regards
Sajid Mohammed.
 
Sir Sajid are these values accurate?

Length of Patch=68
Width of Patch=162
Wo=3.05
$farz(i.e rad box)=123.57
 

Sir this is giving a Dip at some where before 860Mhz where as I want a dip at 900Mhz. Sir what freq are u getting the dip at?
 

the dip is around 910mhz. but shorter the width of the patch you will find the patch resonanting at correct frequency. i did tuning of the patch may be the patch width was not precise but it is still closer to the frequency of operation thanbefore.try shortening it a little bit and see the exact resonance

Regards
Sajid Mohammed.
 
You Are welcome Saad.

Hope you have a better insight into your project

Regards
Sajid Mohammed.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top