Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks,
So, assuming that the best tolerance is achieved between monting holes and components holes, since it is the same process/machine, then a possible solution could be to switch to TH devices and follow the next procedure:
Install sensors on the mechanical part
Mount the PCB to the...
What tolerance should I expect in placement of SMT components, that need to interface to a mechanical part?
Example - two pressure sensors on the same PCB with a cylindrical tube interface need to be inserted into matching holes in a manifold. While the holes position in the manifold can be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
