Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I'd certainly not considered that chip and it might make me rethink my panel choice. I do have an unusual requirement for a panel which has limited me to lvds so far, but I might have another look at the panel options now.
thank you for finding it.
Hi,
I've got a PAL video signal that I need to convert to display on a LVDS LCD screen. I've had a look for off the shelf solutions and not found anything likely apart for some rtd2662 based boards which I can try to reprogram to suit.
I just wanted to check if anyone had any other suggestions...
Thanks for the reply, I was suspecting as much. Your switching idea is clever but I'd be worried about the jumps, I'm very interested in the phase of the S parameters for the downconversion so this does concern me a bit, but I might give this a try to see how it goes.
If not, I'm back with...
I have a set of S parameters corresponding to a dynamic simulation, eg 100 simulations of something moving past and antenna, time 0 to 1 ms (an s paramter result every 10us)
I'd like to use this set of S parameters in a downconversion simulation (whichever package that would suit, ADS, AWR...
Re: Frequency dependant port (MWO)
Cheers for the reply BB.
So I can't really get away without modelling the complete oscillator cct and then doing a load pull... I was trying to avoid this as there's a dielectric puck in there and I'd rather avoid modelling that unless there was an...
Frequency dependant port (MWO)
Hi,
I'm modifying/improving a simple microwave oscillator. I have a device's S parameters (oscillator FET) and I'm constructing the rest of the circuit on the output (harmonic filters etc).
In MWO I would like a simulation setup where I have an source port that...
Hi,
does anyone know how to have an aglient ADS plot marker go to the second highest peak, or a function that I can use to find it for use in a plot equation. I can't see anything that might help in the function list, and the markers don't seem to cover this.
thanks in advance,
I managed to figure it out in the end;
I just had to write
With Optimizer
.start
End With
in the case 2 statement of the user defined parameter sweep watch, with my optimiser settings already setup. I've a few niggles to iron out with my post...
Hi,
Using CST 2011:
I'm running a parameter sweep with the result templates to plot a max point of a S21 plot;
However, I would like to optimise ( or adjust another parameter) to get the S21 back to a desired frequency before I log my S21 max point.
My thinking was somehow to run an optimise...
Hi,
I've a completed layout in ADS and am wanting to produce the artwork for creating the micro strip circuit.
Our lab has a convoluted process of exporting dxf and colouring it in and scaling it a few times. After some playing with the artwork generation in ADS, I've not produced anything...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.