Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your help and explanation.
Yes, my layout is single sided so I will work with your answer. But if I want to draw a defected ground structure, how to define the substrate?
The reference point for the RF input is under the input line. For the DC load, there is a via to the ground...
Hello everyone,
I try to design an RF rectifier using ADS co-simulation. I am confused about the correct definition of the substrate.
I need to define the back side of the substrate as the ground. what is the correct way?
I defined two copper layers (on top and bottom of the dielectric), draw my...
Hi all,
I need to design RF rectifier that operates at two signals.
I'm using ADS2009. I used P_ntone source from frequency domain sources as the input.
I need to simulate the circuit at two signals at the same and different frequencies, but I confused how to calculate the total input power from...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
