Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear edaboard community,
I would like to ask you what is the typical integrated L and C values at 10 GHz resonance frequency in a parallel LC oscillator.
Here is the topology that I am going to use,
Thank you very much.
Kind regards,
Pablo Marco
Yes thank you for your reply, it was what I have been doing. I just realized that I have been missing a point. I would like to share the solution for the community's disposal.
Best regards,
Pablo Marco
I have seen these videos, but they are not related to my issue because in my question I am trying to find the impedance seen through the source, In the videos, the impedance seen through the drain is studied.
Thank you for your response.
So I am still looking for help for deriving it.
Dear edaboard community,
I would like to ask you a question about the following figure.
Could you please help me derive the impedance seen through the source terminal of the pair? I wanted to derive it by myself (using the small signal model), but I could not achieve a result.
The result is...
Hi everyone again and sorry for bothering you.
I still could not answer my question by myself so I would like to try my chance again to get an answer from the community :)
Thank you for your time.
Kind regards,
Pablo Marco
Hi everyone,
I would like to ask a question about the small-signal model of the Improved Wilson Current mirror.
First of all, RL represents the resistance that is seen when we look up through the drain of M4.
I am confused about the G3 node because as can be seen in the small-signal...
Hi, I am an engineering student. I need to measure my OTA's open-loop magnitude and phase plot in Cadence. Since I am going to design a differential-output OTA, I am quite confused about how I should implement a testbench for that purpose. I would be pretty happy If you guide me.
Thanks in advance.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
