Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
i am designing a dc-dc converter with the help of NCP 1377. The mosfet which is connected to pin 5 of NCP 1377 is FDC2612. Problem is that when ever i start the supply the source resistance which is 1.6 Ohm get burned in fact the 1.6 ohm value is ok to get voltage at source 1V or below...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
