Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello!
I want to add peelable solder mask in altium. Actually I want to protect some SMD pads from exposure to flow solder. How can I do it in Altium?
Do I need to add a separate mechanical layer but how could I mark those pads?
Thanks and Regards,
MAT
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.