Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need to give all the pulses to the ir2112 driver with help of Daq card PCIe-6321. Please suggest some idea to shift the pulses otherwise two MOSFETs are dead shorted.
Hello sir,
I was generated the pwm pulses in labview. But I need to delaying the pulses while giving to the inverter for triggering the igbt. Please help how to shift the pulses in labview? Is there any blocks are available for shifting the high frequency pulses(2kHz)?
Sir I have generated pwm pulses using lab view. I need to use these pulses to trigger the pwm rectifier. For this pulses have to be synchronized with the supply frequency. I have no idea about how to synchronize it. Please give me a clear idea.
Thank you,
G.Maheshwaran
Sir I have doubt in basic operations in the circuit because it contains parallel combination of igbt and diode Sir. So please suggest the reference which contains explanation of one full cycle of input waveform.
I bought this IC because it has 6 IGBT in it. But I don't know how to select the pull up resistor and capacitor values for particular application. Please tell me how to use this IC.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
