Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello, I have a project that was made in innovus. I uploaded the .def file.
In cadence allegro I would like to create a die according to the size of the PADs that are in the def file.
If I follow the route specified in the manual, create an idf file, then load def, then I get 2 pictures, but I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
