Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all ,
How we can check with the help of assertion that we achieved proper baud rate ?
for ex if required baud rate is 100 then error of +-1% is allowed. i.e. value 99 and 101 is acceptable. I have around 5-6 standard baud rates in my IP like 9600,115200 . I have to write logic for this 1%...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
