Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanx for the schematic but there are not the same supply i the A and B variant. I did some fault finding yesterday and found a broken power darlington transistor "3-351" and it should be a 2N6053, so now I need to find a supplyer of that or a replacement.
Need a service manual or schematic for the HP 8901A power supply, the +15V is missing after change the shorted diode for the relay coil on the power supplu board.
Hi, I have a SS-7711 that the power supply has gone whit a numbers of cap that has leaked.. After change a number of caps and switch transistor, I discover that the IC1 "B365N" is not ok, a diode and transistor is shorted on the board, is there a schematic on this board? Have trouble to find the...
Have a Velodyne SPL-800i sub that are not working, have tried to find the fault but no luck.. Have changed a IR2113s and a IR2101s that was shorted but it didn't helped. No sound and a resistor (R3 or R4) get rather hot. Haven't found any schematic or SM..
There it is!
But it didn't work out so well.. I get a error: Q0147E.. Seem to be some problem with creating the output file, it look like there is an directory in the AXF file that want to set the output file location. I found the location in the AXF file and change it but got another error...
Were do I run this fromelf command? Have read about this without understand how to run it.. Can say that I'm new with this, haven't used the uVision4 many times..
Re: Programming a flash wiht a AXF file?
It seems to stop (error 59) before it will generate the hex then I click on the download.. Can't find any HEX file.
I got a AXF file that I shall program a flash but then I try to do that with uVision4 and the Ulink it doesn't work (error 59: invalid absolute module). Is there a way to convert the AXF file to BIN or HEX? I got a programmer that accept BIN or HEX that's work..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
