Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Dana,
Please don't feel bad .This question is asked in an interview.(Lost my Job,currently searching).
Duty cycle here means LED is on for half the time of PWM.
If you can suggest any material so that I can study will be helpful.
Regards
Does it have any relation to the power dissipation in the termination resistor.Below statement is taken from an
application note.
"
the
termination resistor is connected to a supply voltage
(VTT) that is one-half the VDD voltage. The dissipation in
the termination resistor is then constant...
The datasheet tells it's size. My question is if they give something like this 32 Meg x 4 x 8 Banks.
How to arrive that size value which is mentioned in the datasheet
Why is pulsed drain current higher than continuous drain current in MOSFETs?
In MOSFET data-sheets, pulsed drain current is much higher than (by 4x) continuous drain current.
What is the reason behind thi
This question was asked to me in an interview.The Question was "What are the precautions needs to be taken when a high speed signal is routed in multiple layers,to avoid SI problems and impedance dicontonuity issues"
My answer was put vias near to the trace where it is crossing,so that return...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.