Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey
I was trying to run oscillator resonant frequency search analysis using ansys schematic. But, I'm getting an error "No oscillator probe present" how do I add an oscillator probe to my schematic.
Thank you.
How do NFC antennas work? I understand that when the reader and tag come in contact, there is an exchange of energy and data by mutual inductance. But I want to know if NFC antennas actually work like normal antennas. Do they radiate, even though technically they can't?
I was able to read about...
Hi, I just started using ADS one day back and I have not been able to enter my load impedance(ZL) value properly in the smith chart utility, Whenever I enter the real part it's value is changing back to 0.3.
Hi,
I used Ansys circuits smith tool to match my antenna. The tool gave me a sub circuit with resistors and capacitors and now the antenna is resonating at the desired frequency. now I want to know about how should I proceed with fabrication ? How do I proceed with fabrication of this antenna ...
Hi, I hope everyone is doing fine.
I designed an antenna in HFSS and used the circuit option along with the Smith chart tool to design a matching circuit. Now, I can see S11, Z11 plots and Smith charts. However, I'm wondering how to import these changes back into the HFSS model so that I can...
okay I'll try that but can the older version of ansys ( like 15.0 ) open .aedt archive files or will there be an error ?
after completing the archive I should then export it to AutoCAD dxf file or is there any other file format which I should do ? Assuming I have to add my matching circuit how...
Hi, I'm currently using Ansys electronics student desktop 2023 R2. I'm wondering after the antenna design and simulation there how should I proceed to with fabrication ? How do i export it as a Gerber or how to convert it ? the export menu under one of the drop down menus only had export image...
Hey! I hope you all are doing fine.
I've been exploring PyAEDT for a few days now. I came across a LinkedIn post that mentioned having an edge over others in interviews when you also know how to work with PyAEDT, scikit-rf, along with a standard tool like Ansys. I'm curious about how to get...
Hi,
I have basic understanding of how a smith chart works and I have used it to match circuits as well ( single stub matching method ) is what was commonly taught and I understand it pretty well. but I have no idea how they have approached the matching using smith chart in this research...
I
I was told more loop area in the middle will help have better read distance. and more over my design dimensions make it difficult to have such small packaging aswell
1705251252
I was not able to use the wave port but I did continue with terminal setup as you suggested. I did check the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
