Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for the reply. But the product reports the same unit for example voltage and I am trying to calibrate to the same voltage to put a correction factor to the voltage. putting up a curve fit, will that fix the issue. Y will be voltage and X will be voltage for that curve fit expresion. It...
Thank you very much for replies. This is a seperate question but its related to 6th polynominal expression. After it is defined for curve fit for sample data. Can it be use it for correction factor to correct the data to match with a equipment as in calibration
I have a set of data, defined by Y=A+BX+CX^2+DX^3+EX^4+FX^5+GX^6.
. I do a calibration of 24 point sample and then do a polynomial curve fit. X would be a voltage, A,B,C,D,E are constants, and Y is a resulting measurement (in engineering units). Lets say, 24 point sample points are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
