Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If I store an electronic device with the microSD card inserted is slot for many years, will it cause problems with the card slot losing the pressure to hold it or break?
In your opinion, is this HDD original or fake (microSD card, or USB Flash Drive or SSD) inside the plastic case and software modified to show 1TB and Smart modified to hide badblocks?
I put 300GB on this HDD and it didn't corrupt
Is there a risk of them placing a flash memory inside the case and modifying the smart firmware to show it as an HDD? disguise flash memory
the WD HDD is 1TB Is there any explanation for this graph line from the WD HDD test to stop between 357G and 429G on the Victoria? the information says that the test was completed at 1 TB but the graph stops before
Is this HD good for storing files?
Did you analyze the photos? Are both two HDDs good for storing files?
Another question, one of the HDDs the test graph does not go up to 1TB it stops before 1TB and the test is two minutes shorter, is this normal?
Does the DVD burner drive have a magnet If I store an HDD next to a 3 unit DVD drive, will the DVD drive's magnet generate badblocks and delete files from the HDD?
How many months can a notebook HDD remain unused without damaging its mechanics and data? to keep its mechanics healthy and the...
SSD is more durable than HDD for long-term storage? archiving
If someone modified the firmware and Smart of an HDD to show 0 badblocks and errors, through some testing is it possible to find out?
In my case I only have electronic devices that use electrolytic capacitors, in my case I just connect the device to 220v
So no electrolytic capacitor manufacturer says when the interval for turning on the device is at least how many minutes or hours?
If I desoldered all the electrolytic capacitors from all my electronic devices, there are many of them, it would take a long time and I don't have a variac or resistor, only electronic devices with electrolytic capacitors mounted in the circuit
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
