Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thank you Klaus
1607847121
1607847198
1607847237
Is it possible to run it for 5 hours with maximum load that is 761kg with 4*12 V(48V) 92ah capacity battery with only one time charging
Hi everyone.
I am working on a project to run a rickshaw using solar panels.The load it can carry is 761kg and net power is 1548W and rated speed is 21kmph.I have to connect solar panel to charge controller and then to battery and load.I want to know whether i can use 4 12V batteries in series...
Hi everyone
Hope everyone is safe and sound
I am working on a project which consists of ac source,rectifier and buck converter and a voltage regulation circuit.The input varies from 110 to 120v and output is 5v..I have to design a circuit when the input voltage drops that is when it is less...
Is it not possible to build an ac to dc converter with which has a feedback which can control duty cycle in order to get required 5v regulated output voltage?using PI controller?
How to design control loop for duty cycle.I have gone through few papers .There was a gain Gvd which is transfer function Vout/duty cycle.How to derive this gain value?My circuit consists of AC supply of 110 to 120 V 400hz given to a transformer which give 5V and 4 mosfets connected to LCL...
Hey hope everyone is having a healthy day!
What is PWM Controller?Does it control the output voltage?How can I control the voltage?
I want to design an AC to DC Converter with 115AC ,400hz and single phase input.The ouput should be 5volts regulated and percentage load regulation should be 0.05%...
Yeahh...I
Yeah..I want a non pulsating dc at the output...not pulsating dc...I tried other ways finally got a sine wave the other end and by filters i got non pulsating output voltage but now the problem is the current the circuit is very less...because of which for less values of R the...
This circuit im
This circuit im trying to simulate in matlab.I used 50khz pulse generator,50v dc source,transformer of 10khz 1:4 transformer ratio.And the total output should be a dc component of 200V.
Inverter + lc filter is giving sine output but if amplitude of output is less frequency...
Hey folks,
I used inverter switching frequency of 50khz.It is connected to LC filter.But what ever L and C values I use ,the output frequency is only 2000hz.Im using this in matlab.How to rectify this?.Please give the reason.
Im using 4 mosfets with pulse generator to generate square wave with switching frequency 50khz and dc supply 50V.How to design LC filter to convert square to sine wave.
What values of L and C to be taken.?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
