Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear Sir,
My controlled device is MOSFET & want to control its drive.
So that i can control terminal voltage & current of MOSFET & use it as DC Load.
That is DC Electronic load.
I am mainly stuck in designing of compensator in CV mode.
So would like to design it......
Is there any design...
Dear all,
I want to design control system with feed back & implement PID & compensator in hardware. :-|
I want to use Simulink for it :idea:. Is simulink have any control block & tools for the same .
What will be procedure for using simulink for the design of compensator & PID in...
Is this not a simple error amplifier with compensator then what is the functioning of it ?? :shock: :sad:
During my study i have come across sample circuit whose application is similar to mine. So should be able to use this circuit as it is.
But i am facing problems in over shoot, under...
Thanks a lot for your prompt reply .........
This is very useful information. :-D
To adjust feedback R & C is an trial & error method, because i have tried it.:cry:
Is there any short cut method ??:roll:
So would like to study & design it.........
But how to decide which type of...
Thanks varunkant2k,
Ya i want to build an error amplifier which compares reference voltage & monitored voltage, finally controls the output voltage.
I have searched & come across a ckt but not able to understand it how they have designed it & avoid over-under shoots.
After some goggling i have...
Dear All,
I am new in feedback system designing & designing a control loop with op-amp.
I have come across concept of COMPENSATOR Designing to stabilize system & implementing poles & zeroes in system for that. 8-O
But how to design it & not able to find any good document on this topic ?:-(...
Hi Everybody,
Please can any one who read this thread and have simulink model, send me simulink model of both Buck & boost with open & closed loop.
& to study how the closed loop is done some technical document or link.
my ID is:-
bhuvankanade12@gmail.com
bhuvan_kanade@yahoo.com
Thank in...
Hi There,
I am new in simulation & starting to use Mentor Graphics for simulation. I require your expertise in learning simulation.
I want to simulate PID controller using opamp.
Is there any document & video which will guide me for this ??
Some training material or links will also be...
Dear All ,
I am making a double sided PCb but its having multiple grounds in whole circuit.
1. supply ground
2. analog ground for Op-amp supply
3. Signal ground with respect to signal
4. Digital Ground for Controller.
To avoid EMI/EMC problem & give firm ground i want to do copper pour but not...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
