Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I am designing a circuit so that the input voltage normally comes from the battery (3V - 4.2V) and in charging cases it comes from the adapter (9V). Since both power lines come from the same path, I want to use a single regulator. Can you recommend a regulator that works with Buck-Boost and...
solution
If there is no Crystal (32.768 kHz) for the Internal RTC Unit of the SAMD21G18 Processor in the Designed Board
C:\Users\Berkay\AppData\Local\Arduino15\packages\adafruit\hardware\samd\1.7.10
The line in the file "boards" in the file path...
Hello, I apply what is written on both sites I added the link to, upload the bootloader to the controller named ATSAMD21G18, set the Fuse bit named "BOOTPROT" to "8192 Bytes" value again but bootloader is deleted, the program does not work and the COMPORT of the controller does not appear...
The libraries of the components designed in Proteus are stored in files such as USERDVC and USERPKG. In case of deletion of the program, these files can be copied to the relevant place and the component covers inside can be reused. Does the same situation apply to the designed Pads? Where are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
