Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello, everyone.
You need to build a circuit.
The voltage generated by the TEG is between 0 and 1V.
When it is 0~0.5v, power must be guaranteed to device A, and between 0.5~1V, power must be supplied to device B.
The power generated by the TEG is up to 1W.
How should I configure the controller...
There are many reasons for using the I and Q channels.
To mention just one, it comes down to signal processing theory.
In other words, it has to do with the composition of the signal.
Currently, signals with I and Q structure are used for communication.
To demodulate this signal, a demodulator...
Hi,
Our company provides services to construction sites and we are developing a new service for our sites.
As part of the service, we have to address personally to each worker on the field (address with voice/vibration/light).
At first, we turned towards an RTLS system that can both map and...
Hello.
We are trying to measure the position of the sun even on a cloudy day.
Of course there are sensors like:
-GPS,
-Light sensor
- rain and slow sensor
-Wind sensor
-Temperature sensor
- GPS
-Angle sensor
- Limitation sensor
We are trying to use these to measure the position of the sun.
How...
Sorry, I joined here a few days ago, so I'm not familiar with face-to-face yet.
You're trying to make your needs come true, but it doesn't work out.
Please help me with some action.
Hello.
I'm trying to design a wind generator.
However, there is one special request.
It is to change the gear ratio of the turbine.
In other words, we are trying to cap the output of the turbine and electrically control the gear ratio of the turbine accordingly.
I'm trying to find a gear like...
Thank you for your interest in my problem.
We fixed this issue today.
I am new to this site and have few friends.
I am a radio engineer and electrical engineer.
If there is a problem that needs to be solved in the future, I would like to solve it by connecting with each other.
thank you
The result of examining the entrance resistance of the antenna with a network analyzer
It was 24.5+7.5j.
As a result of simulating in ADS to see the S11 characteristics of the antenna, accurate results do not come out.
What could be the cause? Please help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
