Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
16 pins connector.
But it execute an autoswap so in a later stage my routing is easierto perform.
I have a module between two connectors. These modules are free to pick, they are comming from the same schematic page.
Hello,
you can renumber your schematic design by annotating and chose to reset all references to '?'. Then annotate the design and chose to number the references incremental.
Create a netlist and import the netlist in the PCB editor. In the editor update the components in the place tab off the...
Hello,
-Make the schematic you want to use in the block.
-Annotate this schematic, use the 'PCB editor reuse'-tab. Check the 'generate reuse module' box.
-Create a netlist.
-Import the netlist in a PCB editor and rout it. Export it again.
-Backannotate the schematic in Capture.
-Make a new...
Hello,
I have made modules off an other schematic. Now I want to make the pins swappable.
Is this possible? Because the swap-id is not editable.
Regards,
Bart.
Hello,
I have made a schematic in Design entry CIS. This schematic contains connectors and modules. These modules are made from an other schematic. The pins on the connectors are swappable. Now I have ceated a netlist and imported the netlist in the Allegro PCB editor. Here I have performed an...
Hello,
I'm able to do pin swapping, but the problem is when I do it, the pin is actually moving from it current location. How to make the net name or hierarchical port/offpage connector swap instead of the pin???
Regards,
Bart.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
