Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
But I likely seen on many boards there is only one flash, bios or eeprom attached to store run data (firmware). But in this particular case why 3 extra eeprom attached in board ? I couldn't find the reason why ? I have traced (reverse engineer) all those eeprom connection, 1st eeprom pin 5,6,7...
Hello Everyone,
I am Azhar from India.
Few days ago while I repairing a 24" led monitor I found there is 3 eeprom ic placed in mainboard. And also there is main flash ic placed near to the MCU. So I just curious to know what is the reason to place 3 eeprom in board ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
