Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes...since you interfaced it to a controller, which executes its instructions very fast. Any loose contact or slight disconnection on breadboard will lead to execute a different instruction in lcd and which ultimately doesnt initialize the lcd properly and leads to the problem you mentioned.
I am using MT8870 DTMF decoder IC in my project. I have connected the components as in the datasheet.
I have connected a mobile unit's headset also. Everything is done.
!!!!
The problem is, the ic is not at all detecting any tones and the output pins always show as follows:
STD- HIGH
Q3- Low...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.