Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Op-amp output resistance measurement

Status
Not open for further replies.
J

Junus2012

Advanced Member level 5
Advanced Member level 5
Joined
Jan 9, 2012
Messages
1,552
Helped
47
Reputation
98
Reaction score
53
Trophy points
1,328
Location
Italy
Visit site
Activity points
15,235
Hello friends

So far you have told how to simulate the output Impedance of the operational amplifier (After long discussion :)) , and As you know I am in the phase of the measurement . I attached you this method of measuring the output resistance and I would like to hear your suggestions and opinions too




Regards
 

If I remeber right, you have been previously discussing open loop output impednace of an OTA, which is a somewhat different problem.

Anyway, the present measurement circuit looks straightforward. Any questions or problems related to it?
 
Ok FvM

I just wanted to confirm with you expert guys :), I would consider your reply as a confirmation to use this setup

Thank you very much

FvM said:
If I remeber right, you have been previously discussing open loop output impednace of an OTA, which is a somewhat different problem.

Anyway, the present measurement circuit looks straightforward. Any questions or problems related to it?
Click to expand...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top