Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

flyback transformer simulation using pspice

Status
Not open for further replies.
M

mad_house

Newbie level 2
Newbie level 2
Joined
Dec 18, 2012
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,292
i am wondering, if i cld make a flyback transformer (inductor transformer) in pspice and later use it in flyback smps converter and c for simulations in pspice... direct model of such flyback transformer is not available.. if sumbdy cld help me out in dis...
attaching the inductor transformer wich i want
 

Attachments

  • ind_trans.png
    ind_trans.png
    52.8 KB · Views: 157

Yes. you should be able to simulate flyback transformer in PSpice.
DO you have design parameters available with you? based on that one can model the transformer model

Let's take a example where Flyback primary is 1mH, turn ratio is 1:2, primary and secondary winding resistances are 1m & 2m ohms respectively

Model would be

.subckt FLBTR 1 2 3 4
Lp1 1 2x 1m
Rp1 2x 2 1m
LS1 4 3x 4m ; Primary inductance * turn ratio *turn ratio
RS1 3x 3 2m
K1 LP1 LP2 1
.ends

Connect Pin 1 as primary + terminal
Connect Pin 2 as primary - terminal
Connect Pin 3 as Secondary + terminal
Connect Pin 4 as Secondary - terminal

Hope this helps.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top