Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PCB drill – DIY project

Status
Not open for further replies.

Vermes

Advanced Member level 4
Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


It is a bench drill welded of 3/3 cm profiles and 1,5 cm steel plate.
Shafts are 12mm dia.
You have to add a spring and you may assemble a light.





Link to original thread (useful attachment) – Moja wiertarka do PCB
 

In your place, most people use this simple machine to make boards?

Jack
soppcbtech at gmail dot com
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top