Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Error 628 connection terminated by remote computer

Status
Not open for further replies.
K

kasoma

Newbie level 6
Newbie level 6
Joined
Jul 27, 2011
Messages
12
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,430
Hi There
What causes "Error 628: Connection terminated by the remote computer before it could be completed so the port used was closed"
I have been using a huawei E220 HSDPA usb modem to connect to internet but recently since I started seeing this error from the modem I have failed to use it to connect to internet.
I have the right settings from my service provider such as the APN, I have data on my data card. my modem has never got any physical damage, I tried to use the modem on other computer not mine alone but still the same message comes.
I contacted the huawei website but I found no solution. Please help me out before I consider buying another modem. I believe there is a solution to this.
 

maybe the service provider disconnect your line

did you call them?
 

Hello

Here are some solutions to this problem....

1 Reinstall the modem.
2.Confirm that you have good phone line.
3.Check the router/firewall settings.
4.Re-enable RAS.
5. Check that you are using correct username or password.
 

I am also using this same data card so to solve this problem you need to change the setting in the properties of your network :-just three steps ahead
1. click on the network icon present in the task bar & find your broadband setting.
2. Right click on that setting and select properties.
3.Click on security tab and change the data encryption setting to any other setting except "require encryption" setting.

TRY THIS!!!!!!!

If this does not work
Then you need to change the data card.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top