Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Copy of MXR Distortion + effect

Status
Not open for further replies.
V

Vermes

Advanced Member level 4
Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Visit site
Activity points
22,318


This project was made of a board in a typical small housing with polished panel and neat button.
The panel has to be polished twice, as while drilling holes the previous polish can be damaged. It was done using sandpaper 320, then 1000 and 2000 at the end.
In order to fit the small housing KM22 (84x60x22), you have to adapt some of the elements, e.g. sand the plug-ins, lower the position of the board etc. There is no need to place the battery.
Scheme is easily available on the Internet. It was slightly modified in order to fit the small housing.
Below there are some photos:



Link to original thread (useful attachment) – Kopia efektu MXR Distortion +
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top