Continue to Site

atmega 8535 pullup and pull down and sensor input

Status
Not open for further replies.
D

deepakgupta.rf

Member level 4
Member level 4
Joined
Jul 21, 2010
Messages
77
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Location
jaipur
Activity points
1,820
hello everyone
i use atmega 8535 and use port A for sensor input
sensor like door sensor,pir sensor and some time in water controller in water controller use cd 4069ube for signal getting from tank then interfacing from this IC i give directly to avr .there i am getting confused is there any need with avr input like pull up and pull down
please expalin these terms also
 

Pull-up resistors are used in electronic logic circuits to ensure that inputs to logic systems settle at expected logic levels if external devices are disconnected or high-impedance. They may also be used at the interface between two different types of logic devices, possibly operating at different power supply voltages.
Click to expand...

Pull-up resistor - Wikipedia, the free encyclopedia


AVR has internall pull-up resistors, so you don't need to use external resistors for this purpose, except some special occasions.

**broken link removed**
View topic - Internal pull-up advantages? :: AVR Freaks
https://www.edaboard.com/threads/68923/


Also if you are interested about debounce:

AVR Tutorial: Switch Input and Debounce


Hope that helped.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top