Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Table drill with high precision (10mm)

Status
Not open for further replies.

Vermes

Advanced Member level 4
Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


Main parts:
  • 24V motor from bus windshield wipers (1800rpm 0.25Nm)
  • same steal for the spindle housing
  • lead screw with nut 13mm x 1 mm pitch
  • linear bearing
  • base with a column ( a precision stand for sensors)
  • spindle bearings
  • Morse cone reducer from 2 to 1 (later it can be turn into a spindle)
  • chuck without a key to 10 mm + Morse cone 1
  • sewing machine belt
Most f the elements needed to this device are easily available in shops with used machine tools. The lower spindle bearing is double row oblique, while the upper one is single row.
An useful tool is a Proxxon mini-lathe and a milling machine.
The drill itself works extremely quietly. The maximum beating is under 0,01mm (it mainly depends on the quality of the drill bit).
The resolution of drill depth is 0,01mm.


Link to original thread - Precyzyjna wiertarka stołowa do 10mm
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top