Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Tesla 500VA generator

Status
Not open for further replies.

Vermes

Advanced Member level 4
Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


Parameters:
  • transformer supply – 10kV and 0,050A
  • primary winding - 12 wire coils 3,57mm
  • secondary winding – 923 double enameled wire coils 0,65mm
  • capacitor 15nF
  • toroid over 18pF
The picture below shows the winder to wind the coils.






The flat capacitor is made of polyethylene foil and the covers of aluminum foil. So build capacitor was awash in oil and placed in the housing.




The film below shows the effects of this device – the discharges reach 1 meter which is quite long for that low power.
[video]http://filmy.elektroda.net/14_1306938019.flv[/video]

Link to original thread - Generator Tesli o mocy 500 VA
 

way cool project.

what are the coils under the primary coil table, seems there's 2?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top