Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

voice controlled vehicle

Status
Not open for further replies.
A

adityabvmk

Junior Member level 2
Junior Member level 2
Joined
Dec 23, 2010
Messages
20
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Visit site
Activity points
1,402
i want to interface rf transmitter to 8051 and then send only some of the required words to the receiver...then compare those words in receiver side and correspondingly move the motor according to instructions received....the block diagram is as shown in the attachment.....
 

Attachments

  • DESIGN OF VOICE BASED CONTROL SYSTEM FOR VEHICLES -ROBOT.doc
    47.5 KB · Views: 88

You plan to do a voice controlled robot, i used VB software to speak the command through microphone and send the data through RF, and move the robot, shoot the bullets, dance, etc............. Is it the same thing you are going to do it.....

What is that you have done till now... i cant share the code as i lost it.... i have the RF and 8 bit controller code... but i can guide you in this...........
 
yes i want to do the same....thank u for ur reply....please share the rf and 8 bit controller code.....

---------- Post added at 23:46 ---------- Previous post was at 23:43 ----------

also help me in doing this......
 

will u please provide the interfacing schematic of 89c51 and rf transmitter and rf receiver so that i can implement that on a pcb....
 

thank u....what about the transmitter..both are receiver circuits only....
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top