Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] create slots in OrCAD

Status
Not open for further replies.
M

miskol

Member level 4
Member level 4
Joined
Nov 6, 2008
Messages
75
Helped
6
Reputation
12
Reaction score
6
Trophy points
1,288
Visit site
Activity points
1,814
Hi,

i've this connector for Power (2.5mm) that need to be inserted in a layout. the connector however have through-hole leads with oblong-shaped. in OrCAD layout, i tried to change the shape of the drill holes from round to oblong but cannot, the option is disabled... maybe because holes are definitely just for round-shaped. i then asked the board house about my problem and they were able to change the round-shaped holes to slots (oblong-shaped) for me.

how can i change the shape of the hole from round to oblong by myself so that i dont have to ask the same thing over and over again to the board house?


Thank you.
 

only round type drill holes are allowed in orcad layout plus ( about latest versions i dont have much ideas).
You can provide some special notes in your fabrication layer ( where you include drill table, fabrication notes etc) for the PCB fabricator so that they can cut a plated slot there. I have done it in same boards without issues.

Tools like Allegro supports oblong slots
 
  • Like
Reactions: miskol

    M

    miskol

    Points: 2
    Helpful Answer Positive Rating
Thank you. i'll explore Allegro and maybe try to switch to Allegro instead of OrCAD.
 

OrCad also supports Oblong slots.In pad designer there is option hole type, there you select oval slot.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top