Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help needed ! Explainary for the Comparator circuit. Urgent!

Status
Not open for further replies.
A

AlvinTan

Newbie level 4
Newbie level 4
Joined
Jan 10, 2011
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,320
Hi all,

can anyone explain to me how this comparator works? with formulas? any recommendation on which type of softwares suitable to simulation this circuit?

Thanks.

100_1294657787.jpg
 

There doesn't seem to be much that can be said about it. The CA311 is an equivalent of the LM311 I assume. R128 & VR103 form a potential divider between the +12V and GND to set the threshold voltage on the inverting input. The pullup R129 gives a 5V output (the comparator output is open collector). The strobe pin (6) would normally be left open if the strobe function is not used rather than connected to +12V.

What do you not understand about it?

Keith.
 
with ur explaination, it seem much clearer. appreciated with much thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top