Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

SMA connector footprint

Status
Not open for further replies.
T

the_owl

Junior Member level 1
Junior Member level 1
Joined
Sep 29, 2010
Messages
15
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Visit site
Activity points
1,376
hello everyone,

anyone know the footprint for this SMA connector? I was looking for the footprint for few days but could't found. I would appreciate if u can provide me the footprint for this. Thanks!
SMA.jpg

**broken link removed**
 

no this is Edge Mount Connector... You can use attached SMA Connector for Through hole....
Plz click this link
**broken link removed**[2005.06.30%2009.58.29].pdf
 

No this will be a Surface mount part. You have to be very careful with this because i think you cannot exceed the board thickness by 1.6 mm (63 mils).
 


ohh..so the footprint should be on both top and bottom surface as it is edge mounted??
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top