Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Function generator output voltage change...

Status
Not open for further replies.
T

tomstefanou

Newbie level 2
Newbie level 2
Joined
Jul 8, 2008
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,293
Hello all, i have made a function generator using xr2206



The function generator outputs 12V signals. i would like to have 24V output. How could i do that if possible?.

Thanks in advance...
 

Use a different output amplifier with a respective power supply.
 

i have a 24V source available. the thing is i don't know how to calculate the appropriate resistor values or even how to connect a transistor to do it... i am very noob, so every help will be much appreciated!

Added after 44 minutes:

i am trying to accomplish it using a tl082 but on higher frequencies above 180Khz the voltrage drops dramatically.... any ideas on how to maintain the voltage level until 1MHZ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top