Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need 5V 5A SMPS modification

Status
Not open for further replies.
B

bencyp

Newbie level 3
Newbie level 3
Joined
Feb 14, 2010
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
India
Visit site
Activity points
1,310
Hi,

I have a laptop adapter that generates 18V 3.5A output. Attached is the circuit of the adapter. I want to modify the same for an output of 5V and 5A.

I have made the changes on the resistor (W1) 1K but I am able to increse the voltage, however, when I reduce it below 12V the SMPS starts ticking sound every second (approx).



Can I modify to get 5V output?

Regards,
Bency
 

Hi,
I dont believe, that you can do it if the transformer & L3 will be not changed too...
Than, the Optocoppler need instead the R18=3.9K surly other resistor too. The AZ431 needs minimum 2.5V, than in TLP521 the LED=>1.3V; you have ca. 1.2V on R18, calculate the same current value for it as yet from 18V...(I think-it cant be higher as 330 Ohm)
To end are the snubber and Z2 in (changing)play too...
K.
Check pls for 431 dimensionings Fig.5, 17 & 21.
 

I understand that AZ431 needs 2.5V which I can give by changing R16 and R17 and also by changing R18 I can get the optocoupler to triger at 5V.
The SA12A is a 500 Watts Transient Voltage suppressor which will not make much difference if I reduce the voltage to 5V.

So, all I have to do is reduce the number of Secondary turn and change the L3. Correct me if I am wrong?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top